How Much Do You Know About The Balanced Copper in PCB(二)
Feb 16, 2023
Five, PCB balanced copper design specification
1. During stackup design, it is recommended to set the center layer to the maximum copper thickness and further balance the remaining layers to match their mirrored opposite layers. This advice is important to avoid the potato chip effect discussed earlier.
2. Where there are wide copper areas on the PCB, it is wise to design them as grids rather than solid planes to avoid copper density mismatches in that layer. This largely avoids bow and twist issues.
3. In the stack, the power planes should be placed symmetrically, and the weight of copper used in each power plane should be the same.
4. Copper balance is required not only in the signal or power layer, but also in the core layer and prepreg layer of the PCB. Ensuring an even proportion of copper in these layers is a good way to maintain the overall copper balance of the PCB.
5. If there is excess copper area in a particular layer, the symmetrical opposite layer should be filled with tiny copper grids to balance. These tiny copper grids are not connected to any network and do not interfere with functionality. But it is necessary to ensure that this copper balancing technique does not affect signal integrity or board impedance.
6. Technology to balance copper distribution
1) fill pattern
Cross-hatching is a process where certain layers of copper are gridded. It actually involves regular periodic openings that almost look like a large sieve. This process creates small openings in the copper plane. The resin will bond firmly to the laminate through the copper. This results in stronger adhesion and better copper distribution, reducing the risk of warping.
fill pattern
Here are some benefits of shadowed copper planes over solid pours:
Controlled impedance routing in high-speed circuit boards.
Allows for wider dimensions without compromising circuit assembly flexibility.
Increasing the amount of copper under the transmission line increases the impedance.
Provides mechanical support for dynamic or static flex panels.
hatched copper plane
2) Large copper areas in grid form
Large areas of copper on your board should always be mesh if possible. This can usually be set in the layout program. For example, the Eagle program refers to areas of the grid as "hatches". Of course, this is only possible if no sensitive high-frequency conductor traces are present. The "grid" helps avoid "twist" and "bow" effects, especially for boards with only one layer.
3) Fill the copper-free areas with (grid) copper
Copper-free areas should be filled (grid) with copper.
Advantage:
Better uniformity of the plated through hole walls is achieved.
Prevents twisting and bending of circuit boards.
4) Copper area design example
Copper Zone Design Example
5) Ensure copper symmetry
Ensure copper symmetry
Large copper areas should be balanced with "copper fill" on the opposite side. Also try to spread the conductor traces as evenly as possible across the board.
For multi-layer boards, match symmetrical opposing layers with "copper fill".
copper symmetry
6) Symmetric copper distribution in layer stacking
The copper foil thickness in the build-up layers of the board should always be distributed symmetrically. It is possible to create an asymmetrical layer buildup, but we strongly advise against it due to possible distortion.
picture
Symmetric copper distribution in the stack
7. Use thick copper plate
If the design allows, choose a thicker copper plate over a thinner one. The chance factor of bowing and twisting gets higher when you're using thin plates. This is because there is not enough material to keep the board rigid. Some standard thicknesses are lmm, 1.6mm, 1.8mm. At thicknesses below 1 mm, the risk of warping is twice as high as with thicker plates.
8. Uniform trace
Conductor traces should be evenly distributed on the board. Avoid copper sockets as much as possible. Traces should be distributed symmetrically on each layer.






